GSM Error

[Anonymous]

Just upgraded my QTek 1010 with RUU 3.16.52 - everything went well. Then decided to upgrade Radio stack with version 3.23.01 - something went wrong during update and now I cannot use my Qtek anymore. When booting I see at the bottom of the screen:
R <Empty>
G <Empty>
3.16.52

Help me to recover from this problem

[Anonymous]

Just upgraded my QTek 1010 with RUU 3.16.52 - everything went well. Then decided to upgrade Radio stack with version 3.23.01 - something went wrong during update and now I cannot use my Qtek anymore. When booting I see at the bottom of the screen:
R <Empty>
G <Empty>
3.16.52

Help me to recover from this problem

No problem! Solved!

Just needed to insert the SIM card for the update to succed.

Now I have RUU 3.16.52 and RSU 3.23.01. The phone was purchased in Belgium.

8)

The steps are:
1. prepare an SD card with the RUU_3.16.52 extracted using XDArit.exe (use XDArit.exe to transfer the ROM in c:\program files\RUU\english\NK.nbf to the SD) you need to have a USB SD Card Reader in order to do this. buy one if you have to.

2. prepare a second SD card with the repair files stored in the root directory (RSUpgrade.sa.CAB 4,305,434bytes, and the 2577 folder) just like whoever suggested, but replace the RSUpgrade.sa.CAB on the root of SD with the one you extracted in c:\program files\Radio Stack Upgrade Utility\RSUpgrade.sa.CAB (4,328,441bytes) by running RSU_3.23.01.exe (which had unfortunately caused the failure.)

2. insert the SD card with the RUU_3.16.52. press the power button while performing a soft reset. you should enter the wallaby loader screen. i have version 5.15. press action to flash the ROM to your xda.

3. cold boot your xda. you should see the blud Qtek screen. in the lower-right-hand corner you should see
G
R
3.16.52

4. you may be asked to calibrate your screen by tipping the four corners.

5. press the volume button. insert the second SD card (containg the repair files and the 4,328,441bytes SUpgrade.sa.CAB (NOT the 4,305,434bytes one, because it will cause freezing at 1%!) wait patiently until the upgrade finishes. you may put the xda back to the cradle for power as long as it doesn't reset itself.

if anything goes wrong, start from step 2 again.

[Sebi]

Hi !

This is not work for Me.
Always come back the "1%" error message: (Flash failed. .......)

Please help Me !

[Anonymous]

Hey Sebi,

I have the same problem.

Did you fix it yet?
If yes can you tell me how?

regards,

Silver

[Sebi]

Hey Silver !

I don't fix it. :cry: :cry: :cry:


Regards

Sebi