Need help to go back from WM2003 on Asian XDA for warranty

[k_kirk]

Hi,

This morning my speaker stopped working. All is well otherwise and if I plug in the handsfree I can still hear alarms, music or hold phone conversations. A hard reset did not change a thing either so I reckon I must turn up my XDA (sob sob...) for repairs. I have been running a kitchen variety WM2003 for a while now (thanks to Developers & Jeff)... I downloaded the latest O2 Asia versions from O2 website and tried to downgrae but was told that I do not have a compatible version. Can someone kindly tell me how to overcome the curse? I'd like to solve this asap so I can get the speaker fixed. I appreciate any and all help I can get. Thanks a lot.

K

[k_kirk]

Please ignore.

I sorted this out again thanks to the Kitchen! Cooked a 3.17 ROM on the kitchen and loaded on device and then the plain vanilla 3.20 ran just fine.

My device now looks kosher so wish me luck, tomorrow I shall brave the warrantee boys.! If I'm lucky this will be unreparable and they will give me a XDA II instead huh?

[k_kirk]

This is really strange. Perhaps this post is not appropriate for this forum anymore and should goto General section. I now realize that my speaker is fine. When I receive a call it rings fine.

I just can't hear the other side speaking and the other side can't hear me either. When I plug in the handsfree all goes back to normal and I can hear and speak through the handsfree. This looks like a hardware anomaly to me sincve it started all of a sudden in WM2003 and is still there even after the downgrade to the 3.20 ROM...

Has anyone seen anything like this? I really dread the idea of going to the repair shop and ghaving to live without the XDA for a few days... Thanks a lot for any ideas you may have and apologies for crowding this forum with so many messages.

K.

[ritmo-unido]

Hi Guys,

I need your help :cry: .

I've downloaded the 4.00.16 ROM by mistake, it really didn't tell the ROM number, so now I want to revert to a earlier one and I can't.

I've got the following message: "ERROR: GetDeviceData - An established connection was aborted by the software in your host machine.

error getting devicedata" and then "ERROR 011: EXECUTE REMOTE COMMUNICATION PROGRAM ERROR. Cannot execute the remote communication program. Please make sure that the USB/Serial cable is properly connected."

PLEASE HELP ME, I'M REALLY STUCK NOW AND DON'T KNOW WHAT TO DO... :cry: