I have a (stupid) question

[Mikkel]

I finally got round to switching service from horrible AT&T to T-Mobile (US).

I have an XDA that originally was a T-mo device, it was running the T-mo image when I got it 10 months ago. I had issues with T-Mo back then so I switched to AT&T Wireless. While I was with AT&T, I was running the AT&T image. -Now that I'm swtching to T-Mo I want to run the T-Mo image.

So... I downloaded the 3.14 ENG image from the TMO website. (Including the radio stack).

I ran ADAPTROM to make the upgrader run and went about "upgrading" my device to the TMO image.

The upgrade process went fine. The device rebooted and came up with the TMO OS.

So far so good.

Next, the device itself started upgrading the radio stack. This is where I ran into problems. The radio stack upgrade dies at 1%, giving me a popup message that says "Failed, press ok to restart device"

I have now successfully re-imaged my XDA back to the AT&T image (and radio stack) and everything seems to work.

So... What did I do wrong? What should I do differently?

I apologize for asking if this has been discussed in previous posts......

Thanks
/M

[Mikkel]

All,

I know this probably has been covered several times, I am just a bit overwhelmed by the amount of information on the site...

Is there someone who has a link to a post that deals with this?

Thanks much :-)

/M

[Biso007]

Yes, many posts about this issue can be found here, but it easier to get TMO ROM 4.00.21 and then upgrade the RSU sparately using RSU 6.24 for T-mobile. You can find all the required staff at www.yorch.net. Select "Upgrades" from the side menu.

Good luck :)