AT&T A.30.07 ROM and Volume on phone

[keithke]

So, I'm experiencing what everybody else is with this ROM. That initial volume level starts out soft and gradually increases to the max that I have it set to. Some have stated they like this and that's fine. But, I HATE it :evil: . I can never hear my phone ring anymore if it's in my pocket. Has anybody found a possible registry key or setting somewhere to turn this off?

And if any AT&T folks are listening.. I'd like a setting in the volume area to turn this off or on.

[Dustoff]

Have you check under phone profiles... Ascending Ring change to Standard Ring

Dustoff

[keithke]

I don't have a phone profile, or i should say i don't see any where for that option. In the phone settings area the Ring Type is set for Ring. There is an option for "Increasing Ring" but that's even worse than it is already. I don't think this is what I'm looking for.

[babsk]

Since the WM2003 upgrade on my SX56, 've noticed issues with the speakerphone volume. I can barely hear it in fact. Any thoughts on this one?

[babsk]

Fiddled around with the volume setting, moved it up and down, and the now the volume issue seems resolved. Can't say for sure if that's what resolved it, but it's fine now.

[Swifty]

I'm experiencing the same problem with the AT&T rom.. I'm going to take a look around in the registry later on... before I go installing any apps :)

[Swifty]

Well I have taken a look @ the processes running and can't see anything obvious that would be doing the volume thing..
So I have had a poke about in the registry and have found a section with sound profiles and it has an attenuation property, I have tried adjusting this, and deleting it but still no good :(
Also there is an entry in the registry called Hack and mentioned Vol in the string... but it didn't make any difference when I deleted that either :roll:
If anyone thats a bit more acomplished than myself with the PPC Phone could take a look and find a solution to this, i'm sure many users would appreciated it ;)

[valheru]

Has anyone figured out how to make the volume level constant yet?

[drean]

Any solutions to get the volume working well on A.30.09 ENG yet?

[valheru]

Nope. I just put my phone volume on next to the top setting and the system volume two levels below it. Works fine then. As long as the system volume is two levels below it will not graduate the sound.

[ramram]

Nope. I just put my phone volume on next to the top setting and the system volume two levels below it. Works fine then. As long as the system volume is two levels below it will not graduate the sound.

Another thing try ur Reminder set an Alarm you'll notice that you cannot change the Alarm1 ringtone thus the sound stays low :(..I tried many things in the registry and no luck as well I wish would some1 help us to resolve this Issue, but!! I made contacts with att's support ,I told them about this problem thus I'm not the only one who's experiencing this, lots of ppl sees this ennoying ;) , I hope they would help here...