tomtom 3

[m1bwe]

hello i have upgraded to tt3 when i use the navigater it all works fine once, next time i use it ,it goes to the navigater screen then when i press "navigate to" it frezes and i have to do a soft reset, any ideas as its realy annouing.. thanks peter

[Oggi]

Try adjusting the amount of allocated "program memory".
I had similar problems before, but now everything works perfectly!!!
My setting is 40 MB program memory.

PS. Today I drove around 8 hours in Denmark and Sweden using TomTom 3. Without it I would be lost... :wink:

[m1bwe]

thanks i tried that but its still the same any one else got any ideas. thanks

[Tanguy]

M1bwe,

Because this is all sitting on Microsoft technologies :roll: , I that was me, I would apply the 3 most basic patch of all : 1. Reinstall ttn, or 2. remove and Reinstall ttn or 3. Hard Reset and Reinstall ttn

For me, this would take me 10 minutes as I have few apps. 10 minutes is surely less then than figuring out what the problem is

Intellectually, this is not satisfactory :cry: , but I have found it time efficient :wink: