wm2003se: My Radio version is still not changed

[sethadam]

Hi Guys,
I am new here and I managed to upgrade to WM2003SE by Dr. Stein. Only problem is after the upgrade my radio version is still version 1.08.00, can anybody help assist me please. Thanks in advance.


ROM version: 2.06.00WWE
ROM Date: 06/14/04
Radio Version:1.08.00
Protocol version: 1337.18
ExtRom version: 1.12.925WWE

[[Krueger]Dr.Stein]

You should have the following information if you upgraded using the ROM from my thread Bro.

ROM version: 2.06.00WWE
ROM date: 06/14/04
Radio version: 1.18
Protocol version: 1337.38
ExtROM version: 1.12.925WWE

It seems that not only your Radio but you Protocol was not upgraded as well. That could mean the upgrade was not complete.

[sethadam]

Hi Dr,
Thanks for the reply, it seems I cannot complete the upgrade it seems that very thing seems ok until it begins to upgrade the ext rom, it goes to 3% then it gives me an error, been trying but can't seem to pass that stage. Have tried the next steps as provided but still same error, I am stuck. If you pm me your hp number ,can I call you to help me out thanks a million.

[[Krueger]Dr.Stein]

Is your cradle USB connected directly to your PC or through a hub?

[sethadam]

direct to pc.

[[Krueger]Dr.Stein]

Can you please list the steps you performed?

I shall return to this post but for now I have got to go attend to some work matters.

[sethadam]

I just followed the steps indicated in the procedure of the upgrade. When the error comes up, I followed the steps provided,etc, disconnect the cradle, remove pda from cradle,softrest and setup the upgrade again.

If the protocol and radio doesn't get up graded, is it ok? It seems fine now only thing i notice is that the battery is draining faster than usual.