PDA

View Full Version : Leadtek GPS 9532 & MDA III


lloydalikes
18th March 2005, 12:41 PM
I have the following setup:

MDA III
Leadtek GPS 9532 antenna
MDA/XDAIII specifically moulded Car Holder with RJ 11 connector for GPS & the 'Y' cable feeding from Cigarette lighter to GPS & PDA (Though it's branded XDA I/II)
Tom Tom Navigator 3

However the entire system does not seem to work...

The GPS Antenna comes on flashes red for a while then flashes green roughly once per sec. With both the 'Y' cable and the RJ11 port on the PDA holder the MDA does not seem to want to communicate with the Antenna. I have tried TomTom GPS & WinFast GPS configurator, ceMonitor etc etc...

Not sure if you/anyone has had problems setting it up but if you can please please please help me that would be greatly appreciated.

Com 1 does not seem to exist when I select that one...

lloydalikes
18th March 2005, 02:15 PM
Doh!!!

If you have a similar set up and the error Com Port 1 Error appears go to Settings - Connections - Beam: and untick Accept all incoming Beams - it worked for me

:D

cruisin-thru
19th March 2005, 02:50 AM
Yes Com 1 is the correct port, do as instructed above settings/connections/uncheck beams and also disable any external keyboard driver if installed.