zwaenepoel
29th May 2005, 04:53 PM
My qtek after a reset always go to the bootloader screen (USB v1.0).
I have to take off the battery and wait for a few seconds to power it up again, but it always start as i've done a hard reset.
When it starts again, i have to align the screen, and when it is installing the ext rom, it goes to the bootloader screen AGAIN!!!
If i cancel the instalation, it is recognized by my pc (active sync comunicates fine) but when i want to flash it to correct the possible problems it lost comunication. Goes to bootloader screen but no comunication.
HELP PLEASE !!!!!!
I have to take off the battery and wait for a few seconds to power it up again, but it always start as i've done a hard reset.
When it starts again, i have to align the screen, and when it is installing the ext rom, it goes to the bootloader screen AGAIN!!!
If i cancel the instalation, it is recognized by my pc (active sync comunicates fine) but when i want to flash it to correct the possible problems it lost comunication. Goes to bootloader screen but no comunication.
HELP PLEASE !!!!!!