Problem with WM2005 and MN4.2 and BT Mouse

[ossi73]

I have updated my XDAii with WM2005 (1.60c), everything I tested works fine, but I only have a problem with MN4.2 and an original Navigon BT Mouse.
I have changed the two .ini-files (prefs.ini + spgps.ini) to COM4 (the outgoing port).
Switching on the BT-Mouse the blue BT-LED of the mouse is flashing but after starting of MN the BT-LED of the mouse stays off and there's no connection.
I've never seen the mouse with no BT-LED before, because when the mouse is on BT is also on.
It seems that MN says the mouse to switch off BT ???
With Navio (for example) the connection is working on COM4.
It also worked with WM2003.

Has anybody any ideas?

Greetings

ossi

[SaBo]

I use the GNS 5840 BT/TMC receiver.
It seems that the WM 5.0 BT stack does not allow for serial connection at 38400 baud which is needed by GNS/Navigon receivers.
I cannot connect at all to my receiver.
Error message from CruxView: "Could not set baudrate"

Sascha

[ossi73]

My mouse is running with 4800 Baud and with Navio it works, only with MN4.2 i have this problem.

Ossi

[SaBo]

The original Navigon GPS receiver (Navigon modular) which was shipped with MN|4.x is manufactured by GNS and runs on 38400 baud.

Sascha

[ossi73]

It's an updated MN4.2 (i think 1.5 was the version with my receiver) and it worked with WM2003.

ossi