Event driven application/command execute !!

[jpiek]

This is a nice tool: Event driven application/command execute !!

http://www.kent7.com/holly/wakeapp/

It can start an application or run a command at about any 'event' = Meaning, whataver happens :

On a specific time or when ;

PC card changed
othe IR device discovered
Network (dis)connected
AC Power On/Off
full device data restore
RS232 conection made
data sync finisched
system time changed
timezone changed
Device wakes up

Haven't tested it yet, but looks mighty powerfull !

[ZeBoxx]

Similar tools (non-free, but pretty cheap) are:
MemMaid - http://www.pocketgear.com/software_detail.asp?id=14279
SKTools - http://www.pocketgear.com/software_detail.asp?id=14288

Basically they allow you to modify the Notification Queue :)

[tweakradje]

Thanks Johan. This is what I was looking for a long time.

See it as the Task Scheduler op windows xp. Exept you can also use
system events.

Like playing a WAV file if you turn the device on....etc

One remark to the maker: make the font bigger in the remove section. It is very hard to read which event you are about to delete. Tricky...

Until then is use the free dbview.exe to do this ;O)

Tweakradje