Magician: turn on only in bootloader, can't be flashed

[Alva]

Please, help me in the following situation
I bought Qtek s100 It turns on only in bootloader mode. What was before I don't know.
Now I try to reflash it via PC. I unpacked rom 1.12 from imate and put there file MaUpgradeUt_noID.exe and then ran it. The utility can't see the device information (it is normal) but it can't see the informatin about the rom I'd like to flash. I click @upgrade@ but it says it gather information about the device and nothing happened.
I tried to run again about 20 times, but nothing helped.
I tried to flash it via card using rom-image but there is no invitation to reflash though I flashed via card more than 20 times other htc devices and then everything was ok.
I ran mtty 1.42 and gave command d2s, but it said unknown command. Then I gave d2s command then the device turned off.
I have qtek s110 with broken display. Is it possible to change rom-memory?
Is it possible to get service_manual for magician?
Thanks

[RIPin@]

First of all, did you back up your current ROM to SD before Flashing new ROM.
1. Yes. It's VERY GOOD. Disconnect your device from PC. You need to insert SD with your ROM to the device and Turn On. Press Power or Cancel button (i didn't realy remeber try all). After that device will flash ROM form SD.
2. No. It's VERY BAD. You need to know start address form what device should start after Reset. Sory here i did not know what it is.

[Alva]

Ñïàñèáî çà ïîìîùü!
Ñóòü â òîì, ÷òî àïïàðàò ñ êîìïà øèòüñÿ íàïðî÷ü îòêàçûâàëñÿ. Ïîïðîáîâàë øèòü îáðàçîì ÷åðåç êàðòó (îáðàç ñíÿò ñ t-mobile 1.01). Íà îáðàç íèêàêîé ðåàêöèè.
Äàëåå ïðîáîâàë ñíÿòü îáðàç ñ ïðîáëåìíîãî àïïàðàòà. Àïïàðàò âûêëþ÷àåòñÿ. Åñëè ñ mtty äàòü êîìàíäó øèòüñÿ s2d, òî mtty ãîâîðèò, ÷òî êîìàíäà íåïðàâèëüíàÿ

[oltp]

Hi,

Read this http://forum.xda-developers.com/viewtopic.php?t=46628 about the SD flash

M

[Alva]

thanks, but te problem is the device doesn't want to work with card. No reaction on the card with rom-image, turning off when typing d2s

[oltp]

Don't know where you bought & how much you paid for it (sure hope it's less then a new screen), but sir I guess you're scr*w*d.

Maybe you can replace your broken S110 screen with the one from the S100. There's a rar file on the board, with a detailed description & pictures on howto disassemble your magician, think it's called disassembly.rar.
EDIT You can find it here http://forum.xda-developers.com/viewtopic.php?t=44841

M

[Alva]

thanks, but I think the screen is alive, it shows usb or serial and etc.
As far as i know, there is some diagnostic tests to understand where is the problem. how to activate it?

[oltp]

Sorry I don't know of a diagnostics test. But you can have a bootloader without a working rom. Since you bought the S100 in a bootloader state, that's very suspicious to me. & that's why I advised you to replace the broken screen on your S110 with the one from your S100.

Hope you can sort it out & if you happen to run across a diag. pls update the wiki with it.

Regards, M