GPRS/EDGE Question

[Rothstein]

Is there a way/software that helps gprs to stay connected all the time even if device goes standby?

I remember I had a GPRS Setting software at JAM, where it had this option like 'always stay online' :roll:

[Rothstein]

Nothing?

[eagle 1]

Yes, there is a registry tweak to keep gprs always on...check the wiki for uiniversal or wizard

[Rothstein]

Thanks. Here it is:

GPRS always on

If you want your GPRS (or EDGE) connection to always be on, set the following:

HKLM\Comm\ConnMgr\Providers\{7C4B7A38-5FF7-4bc1-80F6-5DA7870BB1AA}\Connections\|gprs connection name|\AlwaysOn = 1 (DWORD decimal)

And to turn it off:

HKLM\Comm\ConnMgr\Providers\{7C4B7A38-5FF7-4bc1-80F6-5DA7870BB1AA}\Connections\|gprs connection name|\AlwaysOn = 0 (DWORD decimal)

Note that |gprs connection name| will depend on the name you've given your GPRS connection





BUT!

Although I change the value to ''1'', after closing Resco Registry Editor and open again, I see it is still ''0''.. I had the same problem with some other hack. So it seems i can not change or permanently save what I change. You think this is caused by Resco Registry Editor? Should I try some other software or do I forget to do something???
:!:

[eightedge]

Found something that may help.

http://www.breaksoft.com/Blog/Posts/2005/8/Mobile_Registry_Editor_FAQ.aspx

Works for me. :D

[eightedge]

Found something that may help.

http://www.breaksoft.com/Blog/Posts/2005/8/Mobile_Registry_Editor_FAQ.aspx

Works for me. :D