tmr0
07-05-2006, 07:00 PM
After upgrading an i-Mate PDA2K (PH20B 0 B WWE E CDL__001 1.40.00 0 0 1.12.00 12.00) to WM5 BA TuMa v1.3 Release, ActiveSync via USB does not connect successfully.
Have tried all of the following without success:
- hard reset PDA;
- re-flash PDA, tried over 8 different WM5 ROM (including Logout, ArtZ, Ivan) all with the same problem;
- deleted all previous partnerships;
- Windows SP2 firewall disabled;
- set remote-NDIS host to use server-assigned IP address;
- reset IP on host computer (i.e. netsh int ip reset c:\resetlog.txt);
- uninstall/reinstallation of ActiveSync 4.1;
- uninstall/reinstallation of ActiveSync 4.2 beta;
- uninstall/reinstalled USB controller drivers;
This problem was experienced on two separate computers, none of which are running any software that modify the standard windows networking software.
When placed in cradle, ActiveSync on device reports that device is connecting, but, eventually fails with support code: 0x85020010.
Interestingly, when device is restored back to original shipped WM2K3SE ROM (PDA2k_WWE_14000_176_11200.exe), ActiveSync can connect successfully again via USB.
Any other suggestions to get ActiveSync via USB working under WM5?
Also, is it normal that once a BA has been upgraded to WM5, that you can no longer use BaUpgradeUt.exe and must always use MaUpgradeUt_noID.exe for future flashing? I lost the ability to use BaUpgradeUt.exe after the first upgrade.
Have tried all of the following without success:
- hard reset PDA;
- re-flash PDA, tried over 8 different WM5 ROM (including Logout, ArtZ, Ivan) all with the same problem;
- deleted all previous partnerships;
- Windows SP2 firewall disabled;
- set remote-NDIS host to use server-assigned IP address;
- reset IP on host computer (i.e. netsh int ip reset c:\resetlog.txt);
- uninstall/reinstallation of ActiveSync 4.1;
- uninstall/reinstallation of ActiveSync 4.2 beta;
- uninstall/reinstalled USB controller drivers;
This problem was experienced on two separate computers, none of which are running any software that modify the standard windows networking software.
When placed in cradle, ActiveSync on device reports that device is connecting, but, eventually fails with support code: 0x85020010.
Interestingly, when device is restored back to original shipped WM2K3SE ROM (PDA2k_WWE_14000_176_11200.exe), ActiveSync can connect successfully again via USB.
Any other suggestions to get ActiveSync via USB working under WM5?
Also, is it normal that once a BA has been upgraded to WM5, that you can no longer use BaUpgradeUt.exe and must always use MaUpgradeUt_noID.exe for future flashing? I lost the ability to use BaUpgradeUt.exe after the first upgrade.