Cingular 8125 and Logitech Ipod Bluetooth Headphones

[ecomajor]

Hi,
I followed all the instructions on adding a2dp to my ppc, I upgraded the rom,etc and ran the tornado thing. My 8125 sees the headphones and has the wireless stereo service, however, it does not actually connect to them as they even after I find the headphones theyt are still in discovery mode. Any ideas anyone.

[tcl]

I have exactly the same problem. I'll post the solution when I figure it out. I phoned iogear and they told me to set my 8125 to send the audio to the headphones instead of the speaker. Not helpful.

[ecomajor]

upgrade to the latest beta rom 225 and it should fix it

[cborneman]

Had similar problem when trying to send music from phone to the headphones. Found the tool, see attached, that has three small programs. There is a bit that has to be changed to tell the device to send all audio to the headphones, otherwise it just does it for phone calls.

The BTAudioOn forces the bit on. BTAudioOff forces the bit off. Just put them onto your device and run them directly. There is a also a toggle program, but it isn't intelligent. It does not query the system and toggle, but instead has its own tracker which gets out of synch.

Hope this helps. My apologies for not crediting the creator of the program, but I believe I found it at Microsoft's site.

Audio quality was very poor due to bluetooth on device. I tested with very old Cingular ROM. Have not tested with the latest 2.25 Cingular ROM to see if there is any improvement. Used Motorola's Stereo Bluetooth headset and also iPhone Stereo Headset with similar results.