ringtone on bluetooth headset?

[j007w]

I searched for a half-hour on this site and another but couldn't find an answer. Could someone please help?

I'm using MS Voice Command, PhotoContacts Pro and Cardo Scala 500. When the very 1st incoming call comes in after my phone turns on I hear the ringtone via the headset for a few seconds. Then, as soon as Voice Command sounds the alert tone (4 or 5 short tones) the ringtone goes to my phone. All incoming calls after that ring via the phone only while VC sounds the alert.

Question: is there a way to have the ringtone comes through the headset?

BTW, my Scala 500 works perfectly with VC on my MDA otherwise.

Thanks

[j007w]

I tried different settings in VC and PC Pro but nothing is working. Is anyone out there able to have the ringtone go to headset?

Thanks in advance

[j007w]

Figured it out. Thanks

[Dox]

Figured it out. Thanks
Going to tell in case anyone else has the same issue? ;-)

Regards
Dox

[j007w]

I found out the Twilight Zone sound when the phone rings is from the Scala 500 itself--pretty neat. Anyway, I realized that I can click once on the bluetooth headset to initiate VC. Afterwards, I simply do NOT click again to close the audio gateway to allow all sounds from the phone (ringtones, announcements, etc.) to come thru the headset.

If I do this, however, I'll need to click the headset twice (first to close the audio gateway) to initiate VC--not a big deal to me. Hope that helps.