Qtek 9090 Dead - Update not 100%, no reaction, no bootloader

[TryOG]

Hey guys,

I've searched the forum for like 5 hours or so
to find a thread that could help me solve this solution...
I've tried everything that had something to do with "dead"
in the BlueAngel and Blueangel Update etc. section

What it does:
- The screen stays black
- If I try to charge, the Red 'Charging' LED doesn't become red
unless I take the battery out of the Qtek and charge..
Then it gets red (WEIRD)
- No connection with activesync or rom update utilities

What happened:
- Rom update stopped after a few percentages...

If i try to get a new rom in it with or without cradle
with the following rom update utilities:
- BaUpgradeUt.exe:
then I get a Connection Error (101) when I try to update
- MaUpgradeUt_noID.exe:
ERROR 150: ROM UPGRADE UTILITY ERROR
(Rom Utility not designed for this device)
or "Finished" immediately (but it's not finished)
(Depends on the rom I use, and I used like 10 different roms)

Soft reset / Hard reset doesn't work,
I even tried to Hard Reset by holding the
Voice Record button + Power button + Reset button for 2 minutes
(I tried Camera + Power + Reset too) with the battery,
and I tried these without the battery...

No reaction...

If someone can help me, please do... :)

Thnx in advance

[sep]

Maybe you can try thingds from this

http://forum.xda-developers.com/viewtopic.php?p=291989#291989

[TryOG]

Maybe you can try thingds from this

http://forum.xda-developers.com/viewtopic.php?p=291989#291989

Nope, :cry:
I've tried that too, but I don't get the USB or WCEUSB in mtty...
The COM ports don't react.

I know how to use it, because I used it like 10 times or somethin'
But I think the problem is, that I can't get in the bootloader mode
(or any other mode)... So there's no response from my Angel.. :(

Thanks anyway..

[xplode]

have you tryed to remove battery, leave it without battery fo an hour or two then put the battery back and power on the device ?
this method may boot your device. If it worked go imediately in bot loader mode and reflash your favorite rom
If it does not helps maybe it is hardware problem ... and you should leave your device in service center

[TryOG]

Tried this too :(

Isn't there any solution except for service center?
I want to know how I can solve this problem,
'cause it could happen again when I update the rom later.

And I know I'm not the only one with this problem.
It would help me and a lot of other BlueAngel owners.. :(

[Black6spdZ]

Is it possible to make a serial connection with the bottom I/O port and issue the necessary commands with mtty? could be that there is some logic powered on the board but not enough to make the "USB" section powered up.. similar to serial a console cable on network gear etc. OR.. is there any known secrets such as a hardware debug mode initiated with certain pin(s) on the I/O connector.. such as grounding one or two.. any HTC tech documents floating around for troubleshooting?

[TryOG]

:(

[SoftService]

You are not one with this problem. The same happens with me too.
Let searching for solution together. :)
If you want you can contact with me by icq: 190812766