kjymma
21-05-2006, 07:02 PM
Hi All!
I just upgrade my MDA III from WM2k3 to WM2k5 (TuMA 1.4).
All looks very good, but I founf the following problem:
I configure my MDA to use bluetooth hadsfree. When I push the power button to switch off my device, if I receive incomming call, rings only device, but not my hadsfree. When turn on MDA, i see that chackbox indicating on/off bluetooth is unchecked, i.e. mu bluetooth is off. I need to check it again to enable communications between my hadsfree and MDA.
But when my device is turned off, this happens again. In this case i cannot use my bluetooth handsfree, I need to receive phone calls from MDA, and every time manualy turn on bluetooth.
Are there any solutions to fix this problem?
I just upgrade my MDA III from WM2k3 to WM2k5 (TuMA 1.4).
All looks very good, but I founf the following problem:
I configure my MDA to use bluetooth hadsfree. When I push the power button to switch off my device, if I receive incomming call, rings only device, but not my hadsfree. When turn on MDA, i see that chackbox indicating on/off bluetooth is unchecked, i.e. mu bluetooth is off. I need to check it again to enable communications between my hadsfree and MDA.
But when my device is turned off, this happens again. In this case i cannot use my bluetooth handsfree, I need to receive phone calls from MDA, and every time manualy turn on bluetooth.
Are there any solutions to fix this problem?