Receiving files through Bluetooth

[JmJ17]

I've tried to make the reg-hack to activate file reception through bluetooth with OBEX but when I make the soft reset after ther registry mod, the key is again 0 (1 is enable).

Is it possible to activate the receive file profile in TyTN?

[mrleoni]

hi, I don't know if you are experiencing exactly the same problem as me or if yours is a slightly different issue, however I couldn't receive any files via bluetooth on my brand new Vario II. I could send, but I couldn't receive.

I opened up com2 as a new incoming port on my bluetooth settings and voila - suddenly it worked.


Don't ask me why!

[JmJ17]

Thank you MrLeoni for your reply.

I've done what you suggest but I still can't receive files through bluetooth.

I think that this is a basic feature in a PocketPC.

Any idea?

[eva_d]

I've tried to make the reg-hack to activate file reception through bluetooth with OBEX but when I make the soft reset after ther registry mod, the key is again 0 (1 is enable).

Is it possible to activate the receive file profile in TyTN?

did you try to check: start -> settings -> connections tab -> beam -> receive all incoming beams ?

worked with me, i don't need to do any reghack to receive files via BT.

[JmJ17]

Thank you very much eva_d.

Your suggestion works fine. The problem was that "receive all incoming beams" was disabled.

I used to disable this because I thought that when this is enabled, infrared receiver is working and wasting battery, so I used to disable.

After set this option, I've revised the reg-hack about OBEX and I've seen that is 1 (enabled), so the conclusion is that disabling "receive all incoming beams", OBEX is disabled.

Thank again to everyone who has help me. Problem solved.