How to use the MTTY.exe ??

[scorpio16v]

After many tries I think i´m to stupid th use this little program.:D
I´ve connected my Vario II in bootloader mode ,Activesync is disabled.USB is selected.All other checkboxes are default.
I´ve got the "USB" prompt.
If I use the "rtask b" command to enter the GSM AT command interface, I can´t make any inputs in MTTY.I can´t even go back with "returoR" to normal bootloader.
If I disconnect the USB cable the Hermes didn´t change from USB to serial.
What did I wrong?:confused:
It´s Hermes 300; IPL-1.01; SPL-1.04

Thanks for your replies
scorpio16v

[pof]

When you type 'rtask b' and go to GSM bootloader you have no "local echo", that means what you type is not printed on the screen.

To enable local echo you have to type "ate 1" and press enter, also it is good to type "atv 1" for better responses.

To exit, you have to type "retuoR", but sometimes 3 times before it exits.

[scorpio16v]

To exit, you have to type "retuoR", but sometimes 3 times before it exits.
Thanks pof

The word "returoR" semms to be a mistake in the Wiki.:)

[pof]

thanks, fixed :-)

[qq888]

not sure why .. all i got is "cmd" instead of "usb" ... ?:confused:

[suhaspatwa]

when i try to conect mtty with my hermes, it open a window when usb is selected and all other radio default..it shows CLIENT CLEINT
and doesnt allow to enter any command..i can copy paste but command has no effect..what is wrong..i have disabled usb connection from active sync