TyTN + TTN6 issue

[digitaldreams]

Hi!

I'm still having problems conencting the 'TomTom Wireless GPS MkII' to the TyTN using TTN6 (tried both, 6.01 and 6.02).

Current ROM is 1.35.255.2 (11/14/06) installed with and without Ext. ROM, the BT pair is properly configured and attached to COM0 (Secure Connection 'on').

After starting TTN6 the map points to my Home position (the only position it knows) and remains disabled (gray). The GPS receiver is in sync (green led flashing) but BT indicator (blue led) remains solid and TTN6 says...

After various tweaks I found the possible cause... The Phone (2G) should be on when starting TTN6, if not the BT radio doesn't sync...

Comm Manager, GSM 'off', BT 'on': TTN6 doesn't work (GPS status is blank),
Comm Manager, GSM 'on', BT 'on': TTN6 works (GPS status grayed or active).

Can anyone confirm this issue? Tnx.

[fun_key]

Try creating a COM0 port with security off

[Nicky]

I am running TT6 and have used both a Tomtom GPS Mk II unit and one of the cheaper alternative brand of GPS units too.

I did have to set up a port for the non-Tomtom unit on COM4 but for the Tomtom GPS Mk II I didn't have to, all I had to do was pair it.

Try deleting the COM0 that you have set up so there are no COM ports set up for the Tomtom Unit and see if that helps. Also, in the beam settings, if 'Receive all incoming beams' is unticked, tick it.

Hope this helps.