WIFI with a "Conceptronic C54APM" Access Point

[edba2000]

Is it possible to connect the Trinity to a "Conceptronic C54APM" access point with WEP activated?

:confused:

I am able to connect it, give the correct password but I can get no communication!!!

Thanks in advance.

[Matterhorn]

Is it possible to connect the Trinity to a "Conceptronic C54APM" access point with WEP activated?

:confused:

I am able to connect it, give the correct password but I can get no communication!!!

Thanks in advance.
Try taking off the wep protection on your access point, then get the Trinity connnected. If all is well, then add the wep again. Make sure that you check that the "shared" option is the same on both.

[leon100]

Just in case, access can also be restricted/enabled at the MAC level.

[edba2000]

Thanks for the answer.

Even without WEP, I still can't connect :mad: :mad: :mad:

Here is my "Access Point" config:

System
Up time 0day:0h:21m:25s
Hardware Version Rev. A
Firmware Version 1.25
Wireless Configuration
Mode AP
ESSID xxxxxx
Channel Number 5
Security WEP
BSSID 00:xx:xx:xx:xx:xx
Associated Clients 2
LAN Configuration
IP Address 192.168.0.2
Subnet Mask 255.255.255.0
Default Gateway 192.168.0.1
MAC Address 00:xx:xx:xx:xx:xx



Authentication Type : Open System Shared Key [X]Auto
Fragment Threshold : 2346 (256-2346)
RTS Threshold : 2347 (0-2347)
Beacon Interval : 100 (20-1024 ms)
Data Rate : 54M
Transmit Rate :
Preamble Type : [X] Long Preamble Short Preamble
Broadcast ESSID : [X] Enabled Disabled
IAPP : [X] Enabled Disabled
802.11g Protection : Enabled [X] Disabled



Encryption : WEP
Key Length : 128 bit
Key Format : ASCII (13 char)
Default Tx Key : key1
Encryption Key 1 : *************
Encryption Key 2 : *************
Encryption Key 3 : *************
Encryption Key 4 : *************
[ ] Enable 802.1x Authentication



* Management IP

IP Address : 192.168.0.2
Subnet Mask : 255.255.255.0
Gateway Address : 192.168.0.1
DHCP Server : enabled


* DHCP Server

Default Gateway IP : 192.168.0.1
Domain Name Server IP : 192.168.0.1
Start IP : 192.168.0.5
End IP : 192.168.0.10
Domain Name :
Lease Time : forever


When I connect my HTC to the AccessPoint, the IP 192.158.0.5 is assigned to it but I can't ping to 192.168.0.2 (the AP IP)
Some other help would be great!
Thanks

[Matterhorn]

Is it possible to connect the Trinity to a "Conceptronic C54APM" access point with WEP activated?

:confused:

I am able to connect it, give the correct password but I can get no communication!!!

Thanks in advance.
You should try and connect your Trinity to another hot spot just to make sure that the Wifi is working properly. If so, you might try resetting your access point by the pin hole on the back, or however your AP resets. Personally, if I'm ever having trouble connecting a device to my network, I turn off all encryption and filtering until I get a connection. The info you gave shows WEP encryption is still on.

[edba2000]

Hi Matterhorn,

Thanks for the answer. The info I gave shows WEP activated, but I did the test without WEP too. The result is the same.

The HTC is working properly and I can connect to other APs. I can't understand what's happening!!!

:mad: :mad: :mad:

[edba2000]

JUST FOUND THE PROBLEM!!!

The power mode must be: "Best Performance" :confused: :confused: :confused:


Thanks to all.