My SVP M600 phone got stuck at Starting screen

[yekanth]

Hi Friends,
My new mobile phone SPV M600 got stuck whil starting showing four lines of messages as shown below.

IPL 2.10.0001
SPL 2.10.0001
GSM 02.07.20
OS 2.10.1.22

Can any one please help me in geting my phone to today's screen.

I also attached the screen shot for reference.

[csjneek]

did you try a hard reset ?

[yekanth]

Ya I tried both hard as well as soft reset but same screen is stuck again and agian.Can any one please help me in this regard as I am very new to PDA family.

[levenum]

Ok, first things first:
Since you are new to this, are you sure you preformed a hard reset?
It is done by holding power + camera + comm manager buttons (one on the right, two on the left) and pressing with stylus in the reset hole at the same time.

A message should appear asking you to press 'send' (green phone button) to confirm reset.

If this does not help, you may have a serious problem.
Please answer the following:
Is the device fully charged?
Phone will fail to boot if the battery is too low.
Did you install any software right before this happened?
This should have been resolved by hard reset, but just in case I am asking.
Did you change the ROM, attempted CID / SIM unlock?
This could require more serious measures than I can advise on.

[yekanth]

I did exactly the same thing which you mentioned.But even then it is stuck at the same screen.

Ya u r right I unlocked my mobile using a software from eBay.The unlock was successfull and I tried to insert T-Mobile sim, it also captured the signal and I was able to make and recieve calls then after that I wantedly switched off the phone and then tried to start it, there got the problem.

[yekanth]

Can any one help me in this regard please.

[samstown]

I am having the same problem, but my phone is not sim-locked.

[St.Ray]

I'm having the same problem with my G4 QTEK S200:

Attempted to upgrade to WM6 Rom using smart1_wm6_pp8mb.exe
After reboot the phone got stuck at the QTEK Screen
Tried Hard Reset (Camera+Power+Comm+Reset) followed the steps with the same results (bricked)


I also tried re-flashing the rom back to the factory one using RUU_Prophet_220734_2207114_024721_QtekWWE_Ship and ROMUpdateUtility-NoVendorID.exe in Windows Vista with WMDC (Windows Mobile Device Center v. 6.0.6873) and the phone in boot loader mode (tri color screen) with working USB cable, with windows firewall disabled and symantec AV disabled as well, RUU keeps saying error 260 "the update utilitiy cannot connect to your pda phone..." .

Do you think I should try this process using XP instead? No matter what i try i keep getting the error 260 :confused:

Any help would be greatly appreciated :(

[St.Ray]

it was definately a Vista issue. once i tried it in XP with ActiveSync it worked like a charm and i got my phone back up and running. also used spb backup and restored all my settings. :D

[martinezdesign]

i got the same problem with new rom wm6, and the 260 eror, my problem is that i have xp and the activesync does`t connect ...
... means i cant redo the original rom ????
PLEAAASEEE HELPPPP !!

[yekanth]

Please Can some one advice me how to get my phone back.

I raised the same issue 7 months back after that my phone got recovered automatically and there were no issues till last month. Last month onwards it is again got the same problem and now it is permenantly stuck at that screen what ever you do.

[philocritus]

Please Can some one advice me how to get my phone back.

I raised the same issue 7 months back after that my phone got recovered automatically and there were no issues till last month. Last month onwards it is again got the same problem and now it is permenantly stuck at that screen what ever you do.

A rom reinstall on xp solved my problems on that one. retry a couple of times! It may not work the first time! hard reset as well...
Try an official wm5 rom just in case
good luck

[yekanth]

HI Phil,

I am new to these kind of installations:( . CAn you please Gimme step by step procedure for ROM installation.

[collywog19]

mine is now also stuck, after trying to install new rom. wont connect to active sync either, have i fooked it? tried hard reset etc.

thanks

[triplejay]

(with a turned off phone, press and hold camera button then insert USB cable)

then flash provider ROM


RECOVERING FROM ERROR IN STEP 8 WM5->WM6
1. Don't panic
2. Don't panic
3. Unplug the phone
4. Reset with stylus,and keep the Camera Button pressed.
5. A 3 color screen will appear(Bootloader Screen)
6. Connect your device with your PC,and run the NVID(no vendor) WM5 rom.
7. The device will be resetted after RUU(rom update utility)finishes
8. Repeat the WM6 upgrade,from STEP 5..

from here http://forum.xda-developers.com/showthread.php?t=310452

[collywog19]

hi jay

i seen your post in n00b guys one, i fixed it!!!!, thank you so much, i couldnt remember how to get it to those 3 colours.

thanks again

Colin

[yekanth]

Hi,

I am unable to get the NVID ROM. The Rapidshare link that has been provided in the other thread is not working. Can some one tell where can i get the ROM.

[triplejay]

i seen your post ...
no problem mate.

..and yekanth i see what u mean about the dead links. i have the files on my computer at home but i'm posting from my prophet right now, so i can't upload. Try using the "pdaviet temp" from one of the wm6 threads?
(http://rapidshare.com/files/54265407/Prophet_PV_Temp.zip)

[yekanth]

Hi,

To mention my phone is from orange-UK. I got the orange rom from our FTP site and did the flashing/update what ever you say.But still it is getting stuck at the same IPL/SPL screen. Iam very much worried that I will not get a proper solution for my problem.It will be very grate full if some one resolve my problem.

:mad: :mad: :mad: :mad:

[triplejay]

just seems strange...how did you fix it last time? did it just start working again? A random guess would be that the camera button got liquid spilled on it or is stuck in.
If the camera button is pressed in the phone will go to 3 colour screen every time it is turned on.
It won't do any harm if you try to press/move that button to see if u can "unstick" it, not likely I think but u never know...

[sjeik]

hy there since i am new whit pda`s and tri to flash wm6 form pdaviet on
my spv m600 i got the same problem it stuck`s on the boot screen and noting
works any more
i dit a hard reset noting hapend no message say pres green button
and i kan not setup an usb conection on my pc whit active synk
so it is not posible to reflash my phone
pleas help to get my new divece running!
i have surged for a sd card flash program but can find any thing
many thx

[nyco]

Hi,

I've got the same probleme after flashing my SPV m600 (G4). But when i've got the 3 colors 'screen, i can flash with wm5 rom.

When i reset the phone, it work 3 or 4 hours with no pb, but after...freeze :/

to unlock it, i can't do reset, i've plug the power supply, the orange led rise and after i can switch on the phone.

If i always plug the power supply, the phone never freeze.

an idea ?

sorry for my english :/ ( need a teacher LOL)

[ilovep9]

do spv m600 got code lock ???

[scottrotton]

Hi im new to all this and want to upgrade my M600 to wm6, can anyone advise me on what I need to download buy or do! and has anyone got this working on this phone yet as I have only found people saying they have had problems so far and none saying it work fine!! a little concerning but Im sick of this phone freezing all the time even after a hard reset :( any help would be muchó aprreciated

Thanks

Scott