Ringtone Vibration Even When Volume Is OFF!

[xwired]

I've got a problem here, I've been messing around with the Notifications registry entries and of late, I've noticed that when I put the phone volume to OFF, the phone still vibrates on incoming calls. However, other events will automatically be muted.

Can someone point me to the right Registry key that would change this behavior? Previously the vibration will automatically stop when the volume is off, regardless of the type of event. Thanks!

[spiderman09]

yes this is irritating! I dont want it to even vibrate for calls or texts at night. Did you figure this out?

Jason

[MikeChannon]

yes this is irritating! I dont want it to even vibrate for calls or texts at night. Did you figure this out?

Jason


Change ringtone/vibrate/LED flash characteristics

If you would like more control over how your device rings/vibrates/flashes its LEDs on events, you can can change the Script values of these events.

For example, for an incoming call performing 'activate device, play ringtone, wait 3 seconds, repeat':

HKCU\ControlPanel\Sounds\RingTone0\Script = "apw3r" (REG_SZ string, no quotes)

For performing 'active device, set volume to 33%, play ringtone, set volume to 67%, play ringtone, set volume to 100%, play ringtone (no repeat)':

HKCU\ControlPanel\Sounds\RingTone0\Script = "ac33pc67pc100p" (REG_SZ string, no quotes)

The following are the full codes available to you.

Please note that all the codes are executed simultaneously except after a ringtone play / wait code. E.g. 'v1p' will vibrate and play at the same time, while vibrating for 1 second. But 'pv1' will play the ringtone through all the way first, then start vibrating for 1 second. a = activate device

cN = set volume to N in percentage max volume
fN = flash notification LED for N seconds
p = play ringtone. Note that this will play the ringtone all the way through before continuing with the next code.
r = repeat. Note that this should be the last code in your Script string, if used at all. The repeat will be from the most recent a. So: v3apr will vibrate once then repeat the ring signal.
vN = vibrate for N seconds
wN = wait for N seconds. Note that the device will wait this long before continuing with the next code.

Cheers
Mike

ALL THIS INFO IS ON THE WIKI