reddragon284
29th March 2007, 01:31 AM
I have a T-Mobile Vario II. Included was a wired headset with in-line volume slider and push-button.
At present holding the button down for a few seconds launches the pre-loaded voice speed dial software. However, I have installed Microsoft Voice Command 1.6 and want to change this button to launch the voice command software instead of the Cyberon software.
I've been digging through lots of forums including this one and found many references to using BlueTooth headsets but not the wired one. Lots of them refer to the reg key [HKLM\Software\OEM\VoiceCommand\] Path. The path value doesn't exist on my device, and creating it didn't make any difference.
Has anyone found a way of changing what this button does?
At present holding the button down for a few seconds launches the pre-loaded voice speed dial software. However, I have installed Microsoft Voice Command 1.6 and want to change this button to launch the voice command software instead of the Cyberon software.
I've been digging through lots of forums including this one and found many references to using BlueTooth headsets but not the wired one. Lots of them refer to the reg key [HKLM\Software\OEM\VoiceCommand\] Path. The path value doesn't exist on my device, and creating it didn't make any difference.
Has anyone found a way of changing what this button does?