XDA2 - various problems.

[Hyperbaric]

Had my XDA2 running on WM5 for a while now.

Yesterday, I noticed it wouldn't power on - so reset it and when it did power on the battery level warning was showing, even though it had been charged in-car during a long drive. The device felt very warm.

Since then, other issues are appearing. While on a call for example, the backlight started flickering randomly before the screen went dead. Also, the device seems to stop responding to key and screen inputs - although at times it is just extremely sluggish and will actually respond if left for a minute or two. After one reset, everything worked except no sound output - this then worked OK after yet another reset and it seemed to be fine for a few minutes. It is now sitting with the battery out after it crashed following another reset.

Had a search for similar symptoms, but not found much. Can anyone point me in the right direction? I.e. loose connection, memory fault, software issue?

[Rudegar]

sounds alot more like batt or backu batt issues

[Hyperbaric]

Cheers Rudegar.

Will search some more on battery issues.

[wic1234]

Hi!

Plese help me!

I have strange problem with my XDA 2.
I bough it 2 days ago. It was in O2 network.
Now when I unlocked it for my network (polish ERA-GSM) I saw that when I'm calling I cant hear anything. Person from the other sight can't hear me too..

XDA have sound becose I used media-player ando other sound stuff, thats why I think that speaker is ok. Microphone is ok too becose I can record animations with sound. And the cable speaker and microphone works.. so what cind of problem could it be?

1. No sound from main speaker and microphone when I'm dialing. (sound works corret only after hanged call)
2.Cant see any contacts from sim card ;/ (on other phone it is and works perfectly)..


So what should I do now? ;/

Plese help...

[paul ch]

I've had simular issues with my xda II also like:
sound would come and go, this would coincide with the storage card also not been able to be seen. In my situation i tracked it to one of the ASCIC chips on the system bord and aplied some arldite glue to set the bord arould the chip regid it still miss-behaves but not as often.

[Maggy]

In my situation i tracked it to one of the ASCIC chips on the system bord and aplied some arldite glue to set the bord arould the chip

sounds like some expert re-soldering would have been a lot better solution... but the glue now prohibits that and I do not know a safe way to remove the glue...