Qtek 2020 stays in bootloader

[ekkoper]

Hi there,

I upgraded to WM5 but wanted to downgrade to WM2003. But halfways the downgrade the PDA hung. The only thing I can see in the screen is Serial at the top and v1.06 at the bottom. When I put the PDA in the cradle, Serial changes into USB. When I try to install firmware from a ROM, after a while I get an Error 101: Connection Error. I think that in some way the connection cannot be esthablished between cradle (PDA) and the computer.
Trying a soft or a hard reset doesn''t seem to do anything.

Can anyone help?

[usman_hussain1987]

i have the same problem. it keeps on giving me a connection error. please can some one help.

[terstar]

the same problem with SPV M1000. anyone have the solution?:confused:

[Ather]

do a hard reset guyz by this method

HOLD DOWN UR POWER BUTTON+RESET (pin at bottom)..u will see 1.06 or what ever ur bootloader version is at bottom and at top u will see SERIAL..when u connect it to USB it will change to USB....and VOILA !!!

Happy Flashing

[Jakkelas]

Did as you said and my computer doen't pick up the connection through the cradle. HELPPPPPPPP!!!!!!

[Rise]

HERE already tried to hardreset and then trying flashing
but can't sucess

[imamlab]

The same problem..
we are on the same trouble...:D

until now, there's no way to resolve this problem,
the lucky if we can connect to PC,
i think its the connector problem,

[Rudegar]

maybe using a new sync cable rather then the cradle then
the cradle was always hit or miss for me
but i still had my wallaby cradle which always worked

[imamlab]

maybe using a new sync cable rather then the cradle then
the cradle was always hit or miss for me
but i still had my wallaby cradle which always worked

I have tried about 3 different cables and the cradle one.
and so tried to 3 different PC's to connect and got same error :D

btw, thanks...

[rhilton]

From what I've seen so far problems can be caused by:
1. A firewall needs configuring or temporary disabling.
2. The usb connection shouldn't be through a hub but straight to the usb on the motherboard.
3. Dubious connection to the cradle.

[imamlab]

From what I've seen so far problems can be caused by:
1. A firewall needs configuring or temporary disabling.
my firewall is active exception activesync service
some time disable

2. The usb connection shouldn't be through a hub but straight to the usb on the motherboard.
i have modding motorola like e398, e1, e2, L7, v3i etc before
i never use USB-hub, i have 8 port USB straight to motherboard, :D

3. Dubious connection to the cradle.
i dont understand about this (dubious ?)
when dopod 838 friend connected to my PC it was OK, no problem, :)

thanks rhilton

[jameshobq]

Have checked your phone connector? it happened to me once:1 pin was out and no way to sync !!!

CENTER]ion[/CENTER]my firewall is active exception activesync service
some time disable


i have modding motorola like e398, e1, e2, L7, v3i etc before
i never use USB-hub, i have 8 port USB straight to motherboard, :D


i dont understand about this (dubious ?)
when dopod 838 friend connected to my PC it was OK, no problem, :)

thanks rhilton

[Dashmeth]

Have d same problem and i've tried all these but no change. Any newer ideas ?

[Dashmeth]

Have d same problem and i've tried all these but no change. Any newer ideas ?

[Dashmeth]

Have d same problem and i've tried all these but no change. Any newer ideas ?