PDA

View Full Version : Do I now have a brick too?


yzf750
8th May 2007, 06:20 AM
Well I didnt even do it on a rom flash. All I did was start installing MS net compact on my mda since I needed it to run a new program. As it was installing I hit the camera button while setting it on the desk by mistake and the screen slowly faded out to black. MDA wont restart now, wont even power on and I cant even get to the bootloader mode using the power button and camera button. GRRRRRRRRRRR Any ideas?

bwesty
8th May 2007, 07:07 AM
completely discharged battery?

yzf750
8th May 2007, 07:21 AM
no, fully charged. I said screw it and took a circuit board out of a busted screen mda I had laying around that I bought for 20 bucks off a guy. Of course the volume tab was broke off the slider in that one so now I dont have a way to use the slider. You just cant win I quess. It least it boots fine with the other board in it. Anyone know of a fix for a broke volume slider?

Junner2003
8th May 2007, 07:39 AM
Take off the battery for half an hour or so, then try to start the WIZ again afterwards!
While removing the battery hold the power button and continiue to hold it for 30 seconds after you removed the battery! Leave the device without the battery for at least 30 minutes!
When placing the battery back in to the device hold the power button before doing so and keep holding the power button while putting in the battery. Wait a few seconds when done and try then to power on the device!

If nothing happends press and hold the CON button on the left together with the VOICE DIAL button on the right and make a reset while holding those buttons.

Let me know if it worked!

gonchi
16th August 2007, 12:28 AM
:( I tryied to install a rom and after following all the instructions I made a hard reset then my phone stay's in the boot screen without continuing!!; my question is do I have a brick or there's a way out!!
thanks
Gonzalo
:confused: