Launch Engineer Mode

[Sjaool]

I'm just curious but what is this for?

*#*#364#*#*

You have to do this on the dialpad.

[uniqueboy]

Are things like that to set up operator setting, things such as how many rings before your answering service picks up?

[Sjaool]

I did a search on the internet and found The HTC Wizard Handbook (http://www.htcwizardweb.net/book/print/103) and it explained how to get the engineer mode working although I had to install fieldtest.exe (http://wiki.xda-developers.com/index.php?pagename=Hermes_Utils) to get it working.

Engineer mode in AKU2 ROM

It was already noticed that the HTC Wizard has registry settings reffering to an engineer mode, but in previous ROM versions it did not seem to work. In the new AKU2 ROMs however, it does. You can enable engineer mode as follows: [adsense:300x250:3:3]
o Use Total Commander to navigate to \HKLM\Software\HTC\EngineerMode
o Assign a value of 1 to BuildIEngineerModeApp
o Close Total Commander and perform a soft reset by holding the Power Button for 5 seconds
o Power on your device, and wait for it to boot>/li>
o Now dial *#*#364#*#*
After about two seconds, a screen will appear with technical information about your cellular connection. Now the big question is of course, what does all this gibberish mean?