Microsoft Voice Command 1.6 + BT Headset = Doesn't work!

[efiggy]

Hello,

I have Voice Command 1.6 installed on my phone and when I use my headset to initiate the voice command stuff, I get stuck with the crappy Voice Tag software.

This worked perfectly for my Wizard; I just had to change the voice command button to run MS Voice Command and not the Voice Tag stuff. But... I can't, for the life of me, figure it out on this phone! Anyone have ideas? Thanks in advance!

[hondaguy]

mine works fine. here are my settings

voice enabled--yes
voice button--record
availability--password protected
announcement routing--bluetooth only

not saying that this is the only way for it to work, just that mine works and these are the settings i am using. try to turn on your headset, but activate the voice dial from the phone first by holding down the voice recorder button for 1-2 seconds. after you use it successfully, try to initiate a call from your bluetooth headset. other than that, i am out of thoughts. good luck

[efiggy]

Somebody close this thread because I'm retarded as all hell. Sometimes simply rebooting the phone is the best solution. I made sure your settings matched mine and rebooted. What do you know? It works! ^_^ Thanks, guy!

[ID64]

Does it announce calls? Mine only does it for appointments and high importance email :(

[efiggy]

Does it announce calls? Mine only does it for appointments and high importance email :(Unfortunately, mine does it for appointments and text messages/email (you can set it to announce all of them or only high-priority ones) as well -- the ringtone plays in the headset but no calls get announced, even though it's configured to do that. I really miss that...

[MathieuG]

Hello me I seek it in French version
Bonjour moi je le cherche en version francaise