Neil Jones
04-06-2007, 08:43 PM
I've been trying to get my MDA Compact III working with my built-in car bluetooth hands-free system (Land Rover Freelander 2) for the last 3 weeks or so with varying degrees of success, but I think I've messed something up...
Until the weekend, I could enter the PIN my car generated into the phone and it would spend several seconds trying to pair; sometimes it would, sometimes it wouldn't, but it would always take several seconds to make the effort. However, now as soon as the car generates the PIN, it goes straight to "failed to connect", the phone doesn't even give the chance to enter the PIN and shows no indication that anything's tried to connect to it.
Is there anyway I can "flush" my bluetooth settings without a hard reset? I wasn't doing any registry tweaks, the only thing I think I did before it went wrong was selected the "set as hands free" on the list of connected BT devices on the phone.
Any help greatly appreciated!
Until the weekend, I could enter the PIN my car generated into the phone and it would spend several seconds trying to pair; sometimes it would, sometimes it wouldn't, but it would always take several seconds to make the effort. However, now as soon as the car generates the PIN, it goes straight to "failed to connect", the phone doesn't even give the chance to enter the PIN and shows no indication that anything's tried to connect to it.
Is there anyway I can "flush" my bluetooth settings without a hard reset? I wasn't doing any registry tweaks, the only thing I think I did before it went wrong was selected the "set as hands free" on the list of connected BT devices on the phone.
Any help greatly appreciated!