completely bricked my tytn

[knightcapain]

so my story goes as this. just flashing my tytn (x01ht) with a custom built rom from the kitchen, ran ruu as normal and when iit begins at 0% it fails and suggests to me how to correct the mistake by pulling the battery out. so i do that and put it back in afterwards. now it wont even power up. lookup in the wiki to try and jump start it by pluging in the usb power cable, led goes red and put in the battery and led goes black not the yellow that means charging. so now i freak out. try this several times hoping that it will go yellow but nothing.

so i think i have a nice looking expensive brick that i could just pawn for parts or is there still hope left in it. i had flashed it about 10 times before this ever happened.

anyone there to put me out of my misery or can it be revived from the dead

much thanks for any response

[pronor]

Hi, I can just tell you what helped me in a similar situation: Take the battery out, put the charging plug in, (is the light on red than?), put the battery in again. Now press power button, commmanager button and soft reset at once - this is when my came back to tricolor screen. Before that I put a rom file that I renamed to herming.nbh on the empty SD card - I'm not sure if this is necessary, since it didn't start to install the rom from the SD. I hope this may help you.

[knightcapain]

thanks for the response.

thats what i have been trying to do. on a working one it will bring up ktl mode or the led goes yellow for charging but on my brick it doesnt do anything at all, not even the bootloader comes up.