Have i bricked my SPV M600?

[zgi]

HI!

I wanted to upgrade my M600 to AKU 2.2 with 8mb page pool. So I have made rom with 8mb page pool with tutorial on wizards wiki page translate it back to nk.nbf and wanted to upgrade it with RUU...but it stopped by 2% and showed an error. after that my phone turned off and when i want to tunrn it on again it shows RGB screen for about 3 seconds and turns off, if i want to turn it on again
i must take out battery for about 2 minutes, then insert it in and it happens again for about 3 seconds. If i plug in usb while its on it turns off.

Did i bricked it? if not, please help.

Thank you!

[Jesterz]

no you didn't brick it, try and enter the bootloader (hold down the camera button and reset) from there run any offical ROM.

if you phone switches off after you are in the bootloader, you battery is probably empty, only way to fix this is to connect to wires from your charger directly to your phone on pins 1 and 5 and then flash it.

[zgi]

Is it well if i just plug it on wallcharger? Or it must be just two wires on 1st and 5th pin? The Orange LED isnt on when its on charger and when I hold down camera and reset button the phone dosent react at all.

[zgi]

OK! I got into boot loader by connecting wires directly to battery pins and now reflashing.

[paradis_pal]

try my 2.2 rom if you intrested in it after reading teh changes, 6mb with patches to 4mb 8mb 12mb page pool size

hope you like after fixing you phone, and if you can't try RUU_Prophet_220734_2207114_024721_NVID this rom

[zgi]

@paradis_pal: I've tried your rom before i bricked my M600. When i wated to upgrade your rom, it stucked at 85% and then error. It did the same on next 2 tries. So i took the same AKU 2.2, and tried to change pagepool size and i made a mistake somewere, and temporarly bricked my phone. It's working now, thanks to Jesterz. But still please fix your rom, i would like to test it.

[paradis_pal]

I did fix it
it may I exceed the limit of free speace in the ROM, so I UPXed dr_yar_bluetooth.exe, but I swear the old one worked with me
and now it is working with me with Both pdocwrite and nk.nbf hope you like it

[crest_delta]

OK! I got into boot loader by connecting wires directly to battery pins and now reflashing.

hEY BUDDY HOW DID U DOTHIS !!
M having the same errr.

the prophet does not respond to the wall charger at all.My Neo all of a sudden went blank since yesterday.It so happened..

I wanted to make a call, I removed my NEO from POCKET and It just showed the GREEN LED BLINKKING the POWER button dint responded at all..

I reset the NEO and now its not showing any thing

Does not respond to the wall charger nor any LED only thing happen is the phone gets heated on Charging(as usual as it did earlier)

Do U know that trick of stripping the wall charger and than short the pins ...
Which is the 1st Pin from bottom or from top..

ANY OTHER ADVICE