Alarm clock will not stop!!

[dnts]

I set up an alarm clock on my P3600. When it woke me up I didn't get the soft key to shut it off. From that point off - it hounts me. Soft reset the device so many times in the last few hours it's driving me crazy. I will get the wakeup tone right after I soft reset EVERY TIME. and then every few hours during the day. I had MS Voice command which I removed. I tried to set a new alarm but that one just added yet another unstopable reminder. I think I also don't get notification for meetings so maybe something is wrong in the registry???
HELP... I don't want to HR the device.
WM5 by the way.
Thanks,
Nir
By the way - tried to remove the notifications from the queue using pocket mechanics but after soft reset - they all came back....

[ari79]

Had the same problem, what solved it was a hard reset.

[cs_e2]

Had the same problem, what solved it was a hard reset.

had the same problem also...

only hard reset helped...

[BlackBeauty]

what s/ware are you using for your alarms?

[dnts]

I was using the built-in clock.
Just hope that official WM6 is out soon so I have two good reasons to HR..

[fantomex]

i have the very same problem!!! any ideas how to resolve it without HR?

[cs_e2]

i have the very same problem!!! any ideas how to resolve it without HR?

I didn't find any

[[kab]]

sometimes ago i install some 3rd party alarm and remove it, bcoz it did not suit me. and install another one.
but first one left some message in notification queue, which always complain "Cannot find program bla-bla-bla...".
solution: install any software (like SKTools) and look inside notification queue (this queue respond for any notifications/alarms/etc..) and cleanup unwanted notifications.
hope, this helps.

added: sorry - did not read that you already try to do this. but anyway this is a problem - notification queue somehow hold this record which annoy you. you just have to find the way to clean it...

[simonuca]

Same problem here, what I do was recover from a backup taken a day before the problem start. That solve it.
The problem start suddenly...
I try soft reset, turn the device off (remove the battery) and then turn it on again, also do the MemMaid 2.0 stuff with no positive results...
Sprite backup was my solution.

WM5 (factory rom, GPS enabled)
Default built-in clock, no alarm managers or any third party software.

[Mental]

I have same problem on my Orange M700 (standard) and still do, even after a hard reset!? Excuse my possible lack of knowledge, but could this be just an issue with the registry? Or the original WM setup files?

[piouet]

Same problem on S300+. I don't want to make a hard reset.

Does anybody found a registry solution or something less violent ?

[vrexiouz]

hmm.. maybe using alarm software ? that's helped me before.. instead performing HR of course..