Stuck in middle of Upgrade - NEED HELP

[gigafast]

I was upgrading my Trinity to new Mobile 6 but halfway through the load, everything stopped. I didn't disconnect anything, nor did I run out of power. Now I have:

TRIN100:
IPL-0.50

TRIN100:
SPL-3.03.0000

But when I run any original firmware loads, it says "cannot upload due to corrupt image" or "Invalid Vendor ID". I can't boot into a functioning OS anymore, it stops at the Direct Mail screen. I can get into boot loader, but I cannot seem to load any image into the device.

Can anyone help?

[bbkel]

I got the same issue and now stucked on the 4 color bar. :confused:

[pof]

Use splxploit to load HardSPL while it's in bootloader mode, then without resetting your device flash any Trinity WM5 rom to unbrick it:

http://forum.xda-developers.com/showthread.php?t=308691

[darkjedi]

Seriously, people do NOT know how to read. This has been ALL over these forums. But it's the people with 1-9 posts, who don't know what they're doing, asking a million questions, and opening a new thread each time; instead of using the already open threads. THIS is why newbs do NOT deserve to flash their device.

[racerx_]

Pof, do you think we could have a simple sticky.. at least for a couple weeks regarding this issue? cause i think it's just going to keep getting posted

[gigafast]

Got it to work. Thanks. Sorry about the extra post. I didn't see the "Windows" version of the splxploit. Much easier in windows!!