D810_ANZ_WM6_Upgrade_20070709 stuck when trying to install

[moshere]

:mad: Hi,
I tried to upgarde from latest HTC official WM5 ROM, but it stuck after the colored screen, so I've to return to the last one.

Anyone know how to solve?

Thank you
Moshe

[andyhargreaves]

Me too!!

Andy

[dbeilin]

Don't worry. Took me a couple of hours to get it right.

This is what I recall I did to get it working.
After getting stuck on the coloured screen (bootloader) and then finding that every time I rebooted the phone just went direct to the colour screen (bootloader) and would not even boot up for me to active sync, I took some advice from somewhere on this forum as follows

1. Reboot PC, make as many programs as possible are closed down on the PC to close off any open ports.
2. Take out battery of d810 for 30 seconds and then put back.
3. Turn on the phone by simultaneously pressing the on/camera and using a pin in the reset hole for 5 seconds. (Not sure if this actually did anything different from just turning the phone on)
4. Connect the usb cable to the phone.
5. No need for Active Sync to fire up.
6. Execute Firmware.

I recall first executing the official Hutchison 3 WM5 firmware and then
just normally executing the ANZ WM6 one without repeating 1-3 above

I was on MUNS 2.01 WM6 Firmware before trying all of this.

I did muck around with CID unlocker software and a new version of Hard SPL and un-hard SPL. But I am not sure if these made any difference.