liquidd
26th July 2007, 05:09 PM
I have a 6515a on Cingular. The device will turn on and show the Cingular logo with the numbers 1.12 at the bottom. It will then proceed to start the windows calibration screen. You can go throught the calibration followed by the load of the cingular software screen at the begining. When the device resets to start after the load, it goes straight to the HP logo screen where it says "Serial" at the top, followed by "v. 021" at the bottom of the screen.
I have read every thread in this section and no one has had a problem anywhere near mine. I have tried the button press of Power+CAM+joystick+reset, but it still returns to the "serial" screen.
I was wondering if I could just re-flash it some how, and then be albe to use it?
The first three of my IMEI is 357 if that helps any.
Thanks,
Liquidd
Please help
I have read every thread in this section and no one has had a problem anywhere near mine. I have tried the button press of Power+CAM+joystick+reset, but it still returns to the "serial" screen.
I was wondering if I could just re-flash it some how, and then be albe to use it?
The first three of my IMEI is 357 if that helps any.
Thanks,
Liquidd
Please help