PDA

View Full Version : qtek 9100 resets during boot


fraudulent
31st July 2007, 02:02 PM
I tried to use imei-check to remove my cid lock but have run into problems.

first time I tried it things seemed to go fine but it never passed stage 1 and I was adviced on the computer screen that I should disconnect, reset computer and device and try again.
I tried but now the unlocker would report "communications errors" shortly after it had detected the phone as a Wizard.
Now the phone wouldn't boot (it resets itself after I get the Qtek logo screen with IPL (2.17) SPL (2.17) and OS (2.17.7.1))

I tried flashing with an original rom from Qtek (2.17.7.1) and it went well. I again tried the unlocker. exactly the same as the first time, and as the second time after that.

I again tried flashing with the original rom but now RUU wont put the rom on due to error 294 (invalid vendor ID).

the phone is still CID locked, the original rom wont install and it wont boot...
what the f*** should I do?

edit: after getting it to boot I find that gsm radio is not working, the phone does not charge etc.
Something went VERY wrong during the last flashing.

Edit: There seems to be an issue with my hardware. I dont believe that using imei-check software has anything to do with this. the flash-rom chip seems to be damaged.