My TyTN says it lost its memory...

[Hookey]

I have just updated my TyTN to WM6. It all went well (it was renamed frpm TyTN to Hermes200, but I can live with that,,,) BUT, it seems to think it has lost its memory. When I try to start a PIM (Agenda Fusion 8.5) it just wont start properly, it goes on "updating" the appointments and tasks, and the suddenly returns to my start screen. Also, when trying to sync it says "sync can not be completed" too little memory left... And when I tried to delete a task, it said there was to little memory to start the program, and suggested that I should go to "System - memory" and stop some programs there. BUT there were no programs running, and I have 8MB memory for program and 14 MB for storing left... That has been enough before...
Anyone having had and/or solved this issue? Thanks in advance!
/H

[vp3G]

Your device may have a bunch of bad blocks. If you've got Hard-SPL (http://forum.xda-developers.com/showthread.php?t=296722) installed, they can most likely be fixed. :)

[Hookey]

That sounds great! I have read through the post you suggested, but it was a bit too technical for my english, do I just take the "hard-SPL" and install it on my device, and then start it? (I might with this question not only proof that I am swedish, I might also be a bit non-technically-stupid...:) )

[austinsnyc]

instant tall hard SPLv7 which you should have done before flashing anyway to be on the safe side. then download MTTY to your desktop/laptop. start MTTY and in the cmd prompt type info 8 and that will tell you if you have bad blocks. if you do type task 2a if I remember right and that will fix them. its not hard at all if you follow directions carefully. one thing though MTTY only works with XP not vista.

[Hookey]

Thanks for that! You say I should have had it installed before, but I can install it now afterwords?
I have a swedish update to WM6, does that matter?

[Hookey]

Sorry.. I have to have some more help... Should I do i like this:
1) make ha hard reset of the TyTN
2) install Hard SPLv7
3) Download MTTY (what is this..?)
4) "fix it"
5) put my back up back again

I am not so used to this, excuse if I ask stupid questions... My TyTN is though at the moment more stupid than I am. I can not start the camera (not sufficiant memory), not start the contatcs list and the backup I have put back was not properly installed, the textmessages is missing, some settings is not there, I can etc. BUT the phone-part of the phone works better!

i am very much looking forward to some help here!

Thanks in advance!
/Håkan

[Elwyn M3100]

Dunno if this is relevant to me here...

I upgraded to WM6 and already have the SPL bootloader in and a custom, er, rom. Seemed to work ok but towards the end of the day I noticed that the TASKS (ie reminders) wouldn't work, stating out of memory. Now the PIM is corrupt :(