GPRS, EDGE, AND WIFI will not connect!!

[dharvey4651]

Hey guys I am currently using the Black Diamond 2.0 rom and since I have installed it, my gprs, edge, and wifi will not work.

Is there a cab file that will repair this or am I stuck with no internet on my WIZARD untill I change the rom again?

I noticed that when I used NBD 8.3 that there was an auto config network settings when I first booted the phone for the first time. Is there something like that that I can get for BD2.0?

Please help. I am desterate. Thanks in advance.

Dan.

[xeno1]

Assuming that you are on T-Mobile US Try going to this link and it will tell you how to configure all your settings. - http://www.gruups.com/tzones/ There are a whole lot of other posts on XDA that tell you how to do it also, but I had this page bookmarked frow way before I started coming here and the settings are right. There's also cab files around here that will do the settings for you if you look for them.

[dharvey4651]

I actually found a cab file that automatically set up all of that. Thank you though

[kegobeer]

In the future, if your question is directly related to an existing ROM, post it in that ROM's thread instead of starting a new thread. It's always better to post in an existing thread than to start a new thread.

[nycelitemaster]

Hey guys I am currently using the Black Diamond 2.0 rom and since I have installed it, my gprs, edge, and wifi will not work.

Is there a cab file that will repair this or am I stuck with no internet on my WIZARD untill I change the rom again?

I noticed that when I used NBD 8.3 that there was an auto config network settings when I first booted the phone for the first time. Is there something like that that I can get for BD2.0?

Please help. I am desterate. Thanks in advance.

Dan.

assuming you have T-Mobile, check my rom, at the end of the first post you'll see t-mobile pack, install the connection setting cabs from that pack :D

[dharvey4651]

Thank you guys for all of your help. Next time I will post under the specific rom's thread.(My apologies)