Stuck On 95% And Can't Upgrade/downgrade

[jimtoyz]

hi everybody..
i've got a serious problem..
here's the story..

i was trying to upgrade to the touch v7 by mr. gullum.
after downgrading my prophet to the no vendor id rom, i upgraded my device to the touch v7.
next i tried to hard reset my prophet, realised that i can't do it cuz my camera button is not working.
went to a phone repair shop and fixed the button..the solder was..loose? i mean, the thing was unconnected from the pcb.
fixed it and tried to hard reset again.

black screen of hard reset appeared, but when i released the comm button, it went straight to the white screen showing os ver and ipl, spl ver.
tried to hard reset again and failed, it entered the white screen where we can restore rom dumps..i immediately pressed the comm button and camera button again..and it started formatting the bnfs..thing?


still can't do hard reset, tried to flash the no vendor id again, and this is the problem..i get stuck on 95% and after that it jumps to 100% straight away.

tried to flash gullum's touch v7 but i got the message that no device detected...tried pv 5.0.0.0.5b, pv 4.00.0.6, nanoscopic all with same result...

anyone can help?

oh maybe this will help:

when i tried to flash the no vendor id again, what shows up is this..(see attachment) the from image version is blank..

on the 95% where i get stuck, the progress bar on my device turns red as when it happens on the 80%.

thank you, everybody...

[jimtoyz]

hi there,

it's not that usual mistake people make..i think i've screwed my hardware too..

now, my previous problem was unable to hard reset because my camera button was not working..the solder was loose..

i've soldered it and the problem was after every succesful attempt to flash 'no vendor id' rom, it resets and goes to bootloader screen again (tricolor screen)..

late last nite, i tried to hard reset after succesful flash of 'no vendor id' rom (after it resets and enters the bootloader screen)..i succeeded to get into the black screen of hard reset but when i released the comm button, it went straight into the htc white screen without me being able to press any button at all..

everything went well though, and it went to the 'tap screen to set up your device'..at this point i tried to flash the 'nanoscopic' rom (last rom i use before i messed up this phone)..it went well!

after succesful attempt, i tried to hard reset again (no luck again), but after the htc screen shows up, the nanoscopic splash screen appeared!!!

whew, i thought i had my phone fixed already, but when i did a clear storage, it resets and enters into bootloader screen again! i tried soft reset via software and via manual way, and it enters the bootloader screen everytime!

now, i've fiddled some more and i now realise that just by pressing the comm button and doing soft reset can make me go into the bootloader screen..i'm guessing that the technician at the phone shop soldered wrongly...and now my comm button works as camera button too..

i think he accidentaly soldered some other button too to the comm button and that's why i always get into the htc white screen after i release the comm button in the black screen of hard reset..

i'm going to go back to the shop again after work today, but i'm still confused about the way my device enters bootloader after every reset (hard reset and soft reset)..

a friend gave an opinion that maybe, like in desktop, (there's the bios then there's the operating system), the 'bios' of my device is fucked up?

any help greatly appreciated!