Rom Update Failed [Archive]

KA Kueh

01-10-2007, 07:09 AM

Dear all,

I was trying to update my office Himalaya with Wm6 but after several attempts it will stop with Error 112: CE Update Data Error. It will stop at either 2% or 4%. Next I downloaded the mtty and did a "erase" command and immediately after that ran the update program and this time it stop update at 20%.

The real problem now is that after the last soft reset, the machine does not switch on, meaning that I cannot even get into bootloader mode. Is there any way around this problem? Thanks.

Regards,
Kueh.

utak3r

01-10-2007, 07:45 AM

The real problem now is that after the last soft reset, the machine does not switch on, meaning that I cannot even get into bootloader mode. Is there any way around this problem? Thanks.

Were you flashing from bootloader, or a running OS? You should do it from a bootloader...
How are you trying to enter bootloader mode? It's Power+DPad+Reset, hold for a second or two.

KA Kueh

01-10-2007, 08:17 AM

Hi,

The problem now is that I cannot get into the bootloader. There is no display on the screen. I even cannot switch on the device by pressing the power button or removing and reinserting the battery. Non of the know combination of buttons seems to work. No sign of booting and also check the battery with another working XDA II device and battery is good with 90% charge. Tried swapping in fully charged battery also did nothing to help.

What else can I do?

Regards,
Kueh

utak3r

01-10-2007, 08:38 AM

There is no display on the screen. I even cannot switch on the device by pressing the power button or removing and reinserting the battery.

Well, this is normal, if you have erased your ROM.

The problem now is that I cannot get into the bootloader. There is no display on the screen.

OK, remove your battery for some time (several hours that is...) and try again.

KA Kueh

01-10-2007, 08:49 AM

Ok. Thanks.

I notice that in MTTY mode you can execute "task 28". What is the effect to doing that? Thanks.

Regards,
Kueh.

utak3r

01-10-2007, 09:28 AM

I notice that in MTTY mode you can execute "task 28". What is the effect to doing that? Thanks.

Uhh... "task 28" is for formatting your DOC (disk-on-chip). You know... you can do quite a big damage with it ;)