MAC address change

[jockyw2001]

You can run or flash the USPL (see sticky) and set a MAC address of your own choice.

Connect with MTTY and at the command prompt type:
emapiWlanMac 01 02 03 04 05 06 (the six two-digit numbers are the hexadecimal MAC byte values and should be replaced by anything you like)

[h4waii]

Confirmed and working. Thanks jockyw!

[strohrum]

Hi jockyw2001,

yesterday i tried nearly the whole day to change my mac address on my x1. first i made a hardspl for x1. the new bootloader is working.

After that, i connected via mtty. I tried some commands like emapiTest, emapiWlanMac and some other what i found at xda-dev. I only go "command error" in mtty.

Then i flashed the latest rom (R2A) and tried it again with mtty. Same bad results.

There is a posting at xda-dev: NOTE: To use rbmc you need to
authenticate with proper password .... otherwise bootloader returns "Command error !!!" or "Command is Locked!". (if you're using Hard-SPL, this is unlocked, and any address can be read with 2.30.Olipro)

Do i make the same authenticate with the X1 HardSpl that i am able to work with any commands?

Best regards


strohrum

[akumalol]

Spoofing was never easier!