Phone Stuck on TNT WM6 Splash Screen

[nutathis]

I have a G4 8125 that I flashed using the SPL tool and everything worked fine. Today after turning the phone off an back on the phone is stuck on the TNT WM6 screen. When you take out the battery that WM6 screen is still on screen, after a hard reset the phone restarts and gets stuck again and will not go into the bootloader. The battery is also fully charged.

[peter petrelli]

Are you positive that you cant get into bootloader mode? Normally if you can boot up to a splashscreen such as that then you probably can get into bootloader mode. I'd like you to try to get into bootloader mode again just so you can reassure me that you dont have a bootloader.

1.hold down camera
2.use stylus to press tiny hole near infrared port
3.release camera button

These are baby steps I know, but its important that we establish whether you have a bootloader or not.

[nutathis]

Are you positive that you cant get into bootloader mode? Normally if you can boot up to a splashscreen such as that then you probably can get into bootloader mode. I'd like you to try to get into bootloader mode again just so you can reassure me that you dont have a bootloader.

1.hold down camera
2.use stylus to press tiny hole near infrared port
3.release camera button

These are baby steps I know, but its important that we establish whether you have a bootloader or not.


I just tried that and the phone just restarts and hangs at the WM6 screen again.

[Toodeep]

brother had same problem. replaced battery and it fixed it.

[itje]

release cam button when the bootloader screen shows, not before :) same with hard reset, dont ease preassure on buttons before you see format option

[nutathis]

brother had same problem. replaced battery and it fixed it.

I'm charging the battery now and it seems to be charging so when its full I'll try again.

[Toodeep]

his wifes battery was a little bubbled. We switched battery's and it did the same thing on my 8125, ANd my battery fixed his. Something to do with the battery not being able to provide enough draw. But that fixed his. He was one click away from buying a new 8125 when i told him to try my battery.

[nutathis]

release cam button when the bootloader screen shows, not before :) same with hard reset, dont ease preassure on buttons before you see format option

That worked, I was not holding the damn camera button long enough. Time to reflash. Any ideas what causes this to happen, it almost makes me want to go back to the stock rom and stay there.