Has anyone seen something like this? (car holder w/charger)

[sherpa]

This one is for 8525/TyTN. Link: http://cgi.ebay.com/Car-Holder-Mount-for-AT-T-Cingular-8525-HTC-TYTN_W0QQitemZ110179663593QQihZ001QQcategoryZ35193 QQssPageNameZWDVWQQrdZ1QQcmdZViewItem

Just wondering if anyone has seen something like this for TyTN II/Tilt. I wonder if this will work with the Tilt. Tilt and 8525 seem almost identical (physically).

[juicyfruit]

i've got both phones in front of me and if this fits the Hermes, it'll fit the Tilt.

[fil]

i've got both phones in front of me and if this fits the Hermes, it'll fit the Tilt.

dont think it will, go the powered brodit holder for the hermes, and yes i can get my kaiser in it, its marginly out, so theres a lot of stress on the usb port!

[3waygeek]

This one is for 8525/TyTN. Link: http://cgi.ebay.com/Car-Holder-Mount-for-AT-T-Cingular-8525-HTC-TYTN_W0QQitemZ110179663593QQihZ001QQcategoryZ35193 QQssPageNameZWDVWQQrdZ1QQcmdZViewItem

Be careful if you go this route -- I bought one of these for my old Qtek 9100. It worked for a couple of months, then the speaker stopped working. There were loose & broken traces on the internal printed circuit board, and more than a few cold solder joints -- the worst build quality I've ever seen.

[jreed012]

I bought a nice cradle for my Apache from Seido. It wasn't cheap by any means, but it was very well built. I'm hoping they come out with something similar for the Kaiser.

Here's the 6700 version : http://www.seidioonline.com/index.asp?PageAction=VIEWPROD&ProdID=298

If anybody comes across one for the Kaiser, please post. I also am looking for a solution.