ahnt
22-12-2007, 10:11 AM
Well- no more than 8 hours after purchasing my Tilt (on clearance, no refunds.) I have successfully rendered it useless. I've been spending a great deal of time since then attempting to revive the device. I successfully flashed hard-SPL to the unit and was in the process of flashing a new rom. It crashed halfway through. This is when the problem began. Now I have an unresponsive device. Camera + Power + stylus reset does nothing. PTT+stylus reset does nothing
I've gotten the unit to turn on twice (seemingly by pressing just the powerbutton). However these two power ons were about 4 hours apart and I have thus far been unsuccessfully attempting to turn it back on.
When the unit powers on it reads:
KAIS*0 MFG
SPL-1.0.OliPof
CPLD-8
and says Serial
If i plug a USB plug into it at this point the Serial does not change to say USB.
The first time it powered on the new hardware wizard was looking for a few data input devices that I had it skip (i read one thread mentioning a qualcomm device diag mode that had what sounded like similar symptoms). The next time (on a different system, also running XP) nothing was detected at all.
Are we any closer to a JTAG solution?
I feel like I just threw away my new toy.
I've gotten the unit to turn on twice (seemingly by pressing just the powerbutton). However these two power ons were about 4 hours apart and I have thus far been unsuccessfully attempting to turn it back on.
When the unit powers on it reads:
KAIS*0 MFG
SPL-1.0.OliPof
CPLD-8
and says Serial
If i plug a USB plug into it at this point the Serial does not change to say USB.
The first time it powered on the new hardware wizard was looking for a few data input devices that I had it skip (i read one thread mentioning a qualcomm device diag mode that had what sounded like similar symptoms). The next time (on a different system, also running XP) nothing was detected at all.
Are we any closer to a JTAG solution?
I feel like I just threw away my new toy.