Battery Charging Problem

[jphuffs]

If I let the battery on my Wizard run down completely, I can't get it to recharge, either with a wall charger or USB charge/sync cable. I have to replace the battery. Is there a way to jump-start the charging process?
After I put in the new battery I can't even get the Wizard to boot up. I have to reflash with the provider ROM and then flash with my desired ROM. I know I shouldn't let the battery run down, but I have several Wizards that I alternately use, and unused, the battery runs down and then the Wizard won't restart and the battery won't recharge.

[kcguy]

I solved this problem by buying an extra battery, which I keep with me, fully charged in my laptop case. As far as the wizard goes, it will only charge the battery if the operating system is booted and operational. I was lucky to find a site with a whole group of people who had the same problem and came up with a solution that is crude, but it works. Take a usb to mini usb cable and cut the mini end off. Strip the black and red wires, plug it into your laptop or desktop usb port and touch the black to the negative terminal of your battery and the red to the positive. Hold them in place for about 20-30 seconds, place the battery back in the phone and it should boot and then charge normally. Somewhere on this site you will find this information and a couple of posts from people who used basically the same tehnique with a nine volt battery. I can tell you the usb cable trick works, but I haven,t tried the battery approach.
Good Luck!