Wizard Reboots Again, Again, Again - OMAPClock too high?

[extend10]

The first time using OMAPClock - I set it quite high and enabled it to run on startup.

Now the Wizard reboots shortly after the second splash screen comes up.

So it's in an endless loop of rebooting. I am hoping to flash another ROM anyway but never get to the point of Activesync being connected before it reboots.

Using BlackDiamond ROM but need change anyway because I need the Phone Soft Pause feature to work for entering calling card numbers. But that's a secondary issue.

Is there any way to reflash without having Activesync connected?

Or is there any way to remove OMAPClock from the startup folder?

Or is there any way to boot in Safemode without having already installed that utility?

[ambidexter]

at start up press power and camera buttons at the same time to get into boot loader

[extend10]

Thanks - that's encouraging - but after it's in the Red-Green-Blue Bootloader, then what? Can I run the Lokowiz or other utilities? Or can I somehow change the startup folder to remove the OMAPClock?

[extend10]

The updates work OK from the bootloader - thanks.