Strange vibrations

[ghale]

Hi everyone,
I've noticed that my Kaiser randomly during Activesync makes 3 short vibrations.

What the hell are that vibrations??

I've tried to see the applications opened in memory, but I've not found anything.

Someone can explain me what's happening?

It's not QuickGPS, btw.

Thanks,
bye,
ghale.

[ekw]

Most likely, that it would be notifications. You probably set activesync connect/disconnect to have vibrate which will cause that issue. You can either keep it, or just set it to a small sound or no notification at all! Sometimes activesync tends to disconnect/reconnect during a session after it syncs

[ghale]

Ah, ok.
But why it happens randomly?
Why not everyday on every sync?

Thanks for your reply, btw!

[ekw]

Could be alot of reasons. Such as you enabled the feature to go to sleep after x minutes while connected to PC. But sometimes the kaiser wakes itself up, thus reestablsihing the activesync. Another reason could be that the activesync on the kaiser probably became unresponsive and restarted itself. And lots of other possibilites too :)

[ghale]

Ok, very very good.
Do you know a way to disable this, please?

[ekw]

Well assuming you enabled vibrate for activesync
just go to start->system->sounds & notifications->
Disable events (warnings, system events)(to flush out other possible reasons why it may vibrate)
Make sure programs and its subcategory notifications are enabled.

Go over to the notification tab you should see Activesync: Begin sync
disable vibrate
Samething for End sync

if vibrate wasn't selected it may be another notification that goes off
check each event in that notification tab to see which one is enabled vibrate and disable it(unless you wanted it to be enabled)

[ghale]

All right, thanks.
I've do it.

You have been very useful and let me discover an important notification system for SMS/MMS, Wifi and other stuff.

Thanks very much,
bye,
ghale