Signal Reception Question

[anubus12]

I have noticed in the past few weeks that my signal reception has gotten worse. Places where I usually get 3G and HSPDA, now I only get Edge. It's seldom I get 3G anymore anywhere.

I am currently using K's ROM v1.30b. I tried a bunch of different radios as well, but no affect.

I am wondering is there something that can cause the signal to drop like that? Is it ROM dependent?

BTW, I'm on at&t in the midwest.

[anubus12]

No one knows what can cause this?

[mrvanx]

Unless you have handled your device badly then it sounds like a transmitter issue. What radio version are you using? Also go into: start>system>phone>band

tell us what settings are selected.

The reception and etc....is attributed to the radio stack version, nothing else.

[anubus12]

Unless you have handled your device badly then it sounds like a transmitter issue. What radio version are you using? Also go into: start>system>phone>band

tell us what settings are selected.

The reception and etc....is attributed to the radio stack version, nothing else.

Thank you for your reply. I've used the following radios:

1.47, 1.48, 1.50, 1.54 all with approximately the same results. Meaning mostly Edge network everywhere and very very rarely 3G. Whereas it was 3G mostly before.

My settings are :

Select your network type: GSM (Should this be Auto?)

Select your GSM/UTMS band: Auto

[intrglctcrevfnk]

Dont forget that sometimes the problem can be on AT&T's end...

The tower by my work has occasionally gone screwey for a day and all I can get is EDGE, or sometimes 3G with only 1 or 2 bars before switching to another tower on EDGE (normally full bars).

It's happened 4 times in the last year, each lasting only one day.

Go to a friends house or somewhere else and see if 3G comes back. If so then it might just be your local tower, esp. since you have tried so many radios without a difference.


EDIT: just read the above post..

Network type MUST be Auto or WCMDA for 3G to function!!

[mrvanx]

Thank you for your reply. I've used the following radios:

1.47, 1.48, 1.50, 1.54 all with approximately the same results. Meaning mostly Edge network everywhere and very very rarely 3G. Whereas it was 3G mostly before.

My settings are :

Select your network type: GSM (Should this be Auto?)

Select your GSM/UTMS band: Auto

Your troubles as shown in the post above this one....your mode is set to GSM....hence why your device will not work on UMTS/3G unless the mode is set to WCDMA or auto.