internal mic replacement problem

[mariner_heart]

i damaged the internal mic of my magician while trying to change the housing.
so i just removed the mic from the board so that i could solder a new one as there is no service spot around.
the replacement mic i have, has only two terminals but the place from where i removed the mic has 4 (as marked in attached image in red)
and the similar mic is not available.
is there any way i can make the spare mic i have to work on magician.
can somebody guide me where i should solder the two terminals? and put a new life in my old favourite?
thanks a lot.

[tassie711]

Hi mariner_heart,

I'm new to this forum, I bought an internal mic from ebay, the ebay trader's name is e2shop.

I was wondering how you are going with that as I have to replace my mic when I receive it.
Is their any way you could explain to me how to take the old mic off please would be much appreciated.

Regards,
tassie

[Arian57]

hi dood. as in your picture, use a usuall mic and put a 4.7 kohm resistor between 3,4 then wire pin 4 for + of mic and - of mic to pin 3